Around 9.00 am, my senses are at work. As usual I will continue to complete tasks assigned and connect back up the components in the circuit. For a completed assembling the components, PIC board will be tested to ensure that each component can work properly. After finish my work then the next flow is to test the circuit were it is functioned or not. The tester equipment is vibration sensor and LCD display.
This figure show that the way to test the PCB and The LCD display will display the result. In the afternoon, Mr. Mazran give assignments to make sure that I and several friends who understand AT command. Further activities will be resumed tomorrow.
The page are about the introducing the GSM Modem, and about control and monitor via SMS.
No comments:
Post a Comment